When I try to connect to my personal area, I get the following error message:

 I was told to publish the message, so when I try to publish, the result is the same.

When I change the connection destination from the IP address to the connection destination with osp address, this error comes out.

Is there a problem with the connection destination?

Does anyone know a solution?


?error message?

1-Click Publish required

A debug session can't be started due to communication problems. Check if the module is published and try again.

Hi,

As the error message states a 1CP is required for the module. Does the 1CP on the module execute? 

Regards,

Daniel

Daniël Kuhlmann wrote:

Hi,

As the error message states a 1CP is required for the module. Does the 1CP on the module execute? 

Regards,

Daniel

 Yes I do.

I ran 1CP, but when I try to connect to my personal environment, I get the same error again.